Electromagnetic Suspension free essay sample

Electrodynamic Suspension (EDS) Photo courtesy Railway Technical Research Institute Japans MLX01 maglev train Japanese engineers are developing a competing version of maglev trains that use an electrodynamic suspension (EDS) system, which is based on the repelling force of magnets. The key difference between Japanese and German maglev trains is that the Japanese trains use super-cooled, superconducting electromagnets. This kind of electromagnet can conduct electricity even after the power supply has been shut off. In the EMS system, which uses standard electromagnets, the coils only conduct electricity when a power supply is present. By chilling the coils at frigid temperatures, Japans system saves energy. However, the cryogenic system uses to cool the coils can be expensive. Another difference between the systems is that the Japanese trains levitate nearly 4 inches (10 cm) above the guideway. One potential drawback in using the EDS system is that maglev trains must roll on rubber tires until they reach a liftoff speed of about 62 mph (100 kph). We will write a custom essay sample on Electromagnetic Suspension or any similar topic specifically for you Do Not WasteYour Time HIRE WRITER Only 13.90 / page Japanese engineers say the wheels are an advantage if a power failure caused a shutdown of the system. Germanys Transrapid train is equipped with an emergency battery power supply. Also, passengers with pacemakers would have to be shielded from the magnetic fields generated by the superconducting electromagnets. Maglev Accidents On August 11, 2006, a maglev train compartment on the Transrapid Shanghai airport line caught fire. There were no injuries, and investigators believe that the fire was caused by an electrical problem. On September 22, 2006, a Transrapid test train in Emsland, Germany had 29 people aboard during a test run when it crashed into a repair car that had been accidentally left on the track. The train was going at least 120 mph (133 km) at the time. Most passengers were killed in the first fatal accident involving a maglev train. The Inductrack is a newer type of EDS that uses permanent room-temperature magnets to produce the magnetic fields instead of powered electromagnets or cooled superconducting magnets. Inductrack uses a power source to accelerate the train only until begins to levitate. If the power fails, the train can slow down gradually and stop on its auxillary wheels. The track is actually an array of electrically-shorted circuits containing insulated wire. In one design, these circuits are aligned like rungs in a ladder. As the train moves, a magnetic field the repels the magnets, causing the train to levitate. There are two Inductrack designs: Inductrack I and Inductrack II. Inductrack I is designed for high speeds, while Inductrack II is suited for slow speeds. Inductrack trains could levitate higher with greater stability. As long as its moving a few miles per hour, an Inductrack train will levitate nearly an inch (2. 54 cm) above the track. A greater gap above the track means that the train would not require complex sensing systems to maintain stability. Permanent magnets had not been used before because scientists thought that they would not create enough levitating force. The Inductrack design bypasses this problem by arranging the magnets in a Halbach array. The magnets are configured so that the intensity of the magnetic field concentrates above the array instead of below it. They are made from a newer material comprising a neodymium-iron-boron alloy, which generates a higher magnetic field. The Inductrack II design incorporates two Halbach arrays to generate a stronger magnetic field at lower speeds. Dr. Richard Post at the Livermore National Laboratory in California came up with this concept in response to safety and cost concerns. The prototype tests caught the attention of NASA, which awarded a contract to Dr. Post and his team to explore the possibility of using the Inductrack system to launch satellites into orbit